Can any body help me,The GE Mark V control system is windows based or Dos base

Can any body help me,The GE Mark V control system is
windows based or Dos based?

Question Posted / mella

3 Answers
7338 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

Can any body help me,The GE Mark V control system is windows based or Dos based?..

Answer / naren

DOS BASED

Is This Answer Correct ?

18 Yes

1 No

Can any body help me,The GE Mark V control system is windows based or Dos based?..

Answer / prasannashankar

GE mark v control system is dos based system.

Is This Answer Correct ?

16 Yes

3 No

Can any body help me,The GE Mark V control system is windows based or Dos based?..

Answer / kiran kumar

it's actually both. If we configure in Dos we call it as
i-DOS and if we do it in windows we call it HMI.

Is This Answer Correct ?

1 Yes

2 No

Post New Answer

More Instrumentation Interview Questions

capillary type tranmitter using remote seals and capillary tubes filled with liquid of known of known density so if you wanna callibrate it just close block valve just before capilary @ high side & connect druck apply it's calibrated range pressure as normal calibration ensure low side block valve must be closed & if you asking commissioning so this is not a DP type pressure tx so simple if you wanna put in servie this tx just open high side block valve & than low side block same way i do it but still transmitter showing -13 ma.just tell me what i want to do ?

1 Answers Gasco,

What is the purpose of RS Networks

2 Answers

what is LAS in foundation fieldbus protocol?

1 Answers

When doing a liquid seal on a differential flow transmitter , most of the time the sealing liquid will be heavier then the process fluid. For wich application will the sealing liquid be lighter than the process fluid if transmitter is mounted below the process line.

0 Answers Chevron,

what is pico fuse? how this different rom othe fuses and how to locate it inside the card?

1 Answers

what are the use of belew gear in general ??

0 Answers

Can Any body tell me how to check Modbus Settings in ER300N L&T trivector meter?

0 Answers

Can any body help to get Rsemulator 5000 free from internet if possible then give me any link or any help .

0 Answers Engro,

hello.my friends.i am an electronics & instrumentation engineer.i want to know Q1.why lugs use in instrumentation cable termination? Q2.if limit switch not working what to do?

2 Answers

Thermocouple is a transducer but rtd is not transducer why? Both taking heat as a input and giving mv

7 Answers

tell about various protocols used in different plcs

3 Answers Emerson, Samtel,

To become an Instrument DESIGN engineer, is there any softwares or training to become Instrument Design engineer, plz suggest me, Iam very much interested in designing.

0 Answers

For more Instrumentation Interview Questions Click Here