How to force the bit in GE Mark V?
Answer / sd
Use Logic Forcing Page and type in the logic name.
Select the logic name and use the Force/ Unforce tab
Is This Answer Correct ? | 2 Yes | 0 No |
Explain signal isolator
What is the function of a diaphagram
what is the differnt between open loop and close loop ?
how can we measure the level measurement with the help of pressure gauge?
How to isolate a DPT from line in the condition that process must not be disturbed,and process is also critical and no bypass is available.?
If a warning lamp will operate with the ground circuit is bypassed with a jumper wire to ground, what should you check?
How to Calibrate variable Head flowmeter (Orifice), here we dont know High pressure and low pressure then how to apply pressure on HP and LP side ?
What should be hight of CONTROL panel for access & OPERATION What is BIS & INDIAN STD for SAME?
How do you measure g's?
5 Answers Aramco, GNFC, HPCL, Polmon, Thermax,
What is the SCAN time of a DCS/PLC? What is the typical value for scan time of DCS and PLC?
6 Answers Essar, Gasco, Siemens,
1)how we calculate the drum level? and how we select the transmitter range?
Which standard is used for calibration of Control Valves ?