what is difference between HOT permit and cold permit
No Answer is Posted For this Question
Be the First to Post Answer
Why we are using thrust bearing at turbine side?
Which wiring connection is preferred in motor for industrial use?
Explain Gas Turbine startup and shutdown sequences
what is burner management system?
why used three wire in RTD.
what is the relation between flow and pressure.for example relationship between level and pressure is p = phg like that i want ans for this question.and also how to calculate orifice sizing and flow transmitter. pls some one ans for this questions.
wht is mean by dpt(differential pressure transmitter)
What output voltage the proximity switch shows when it is in open enviornment?
in split range control valve,two valve should be in two different line and that should have some distance,and we have only one positioner feed back link.so how we connect one feed back in two control valves?if you have picture please forward me.my email id kb.syamkumar@gmail.com
in natural gas indirect water bath heater,how to prevent the problem of backfire from firetube during ignition...becoz of this backfire performance of wbh is going low.
why we are using magnet for calibration of gas detector?
why we are using negative range like -750 to 0 mmwc in closed tank?and what is the reason can you explain clear?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)