in most industies hormonics present up to some level. what is limit ? and ther

in most industies hormonics present up to some level. what
is limit ? and there effect?

Question Posted / anil_636

4 Answers
6575 Views
Bhel, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

in most industies hormonics present up to some level. what is limit ? and there effect?..

Answer / ashim kumar das

In an industry harmonics are measured as TOTAL HARMONIC
DISTORITION (THD), which permissible limit in most of the
industries is 3%.

No doubt harmonic create losses, moreover puncture of
Capacitor banks,unwanted heating of motor are also the main
disadvantages of harmonics.

Is This Answer Correct ?

10 Yes

0 No

in most industies hormonics present up to some level. what is limit ? and there effect?..

Answer / sachin_pawaskar2001

The permissible harmonic distortion For Volage harmonics it
is 5% & for current harmonics 10%.

Harmonics cause voltage distortion & losses in system.

Is This Answer Correct ?

7 Yes

1 No

in most industies hormonics present up to some level. what is limit ? and there effect?..

Answer / manoj sharma

My dear friends sachine and ashwin please tell me...how
harmonics content is measured...what are the formulas and
procedures to do that...How we can eliminate the
harmonics..how these device works....please clarify...

Is This Answer Correct ?

0 Yes

0 No

in most industies hormonics present up to some level. what is limit ? and there effect?..

Answer / antarjyami behera

Harmonic frequency is a disturbance of the signal

Is This Answer Correct ?

0 Yes

0 No

Post New Answer

More Electrical Engineering Interview Questions

Wht ar the reason for low voltage on consumer side?

6 Answers

Can we use a window type neutral CT instead of a bar type neutral CT. We have an issue with a neutral bar type CT of 800/1 ratio with a Circuit breaker NS800L shneider type, and we want to change it with a window type. Pls advise. Thanks

1 Answers

what is the purpose of the armored for the power Or control cable? How to select the type of the armored?

1 Answers Siemens,

Since phi is the angular displacement between V & I, then why we use phi in power triangle ie. when showing active, reactive & apperent power in triangular manner & if it is ok then where is V & I in the triangle.

1 Answers

In APFC panel, Why on dealy timer is used in Capacitor controlling circuit?

1 Answers

the need of star to delta anddelta to star

2 Answers

i've iocl interview.. if you know the interview process please give me information..

0 Answers

why aggregate is placed all around substation ground.

9 Answers

what is meant by skew width in machines?

0 Answers

how to calculate short circuit current for the busbar