Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / naga
Displacer level measurement is used in interface where two or more different S.G available.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
can anyone can let me know in Eurotron Micro cal 2+ calibrator in milli amps source mode we are not able to get 20 milli amps output it only produces 1.52 milli amps out, but display shows increase in milli amps , and err6 displays, let me know how to remove the err 6.
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
how to calculate range of level transmitter?
What is force balance principle? State some of its’ advantages.
What is the reason PT speed not incresed in gas turbine?
Hi Friends , i need one urgent help , i am preparing for M.tech entrance examination , i need some obejective questions related to instrumentation field. where can i get those ? can anyone help me pls ?
How can measure flow in oil line?which type of transmitter is generally used?
how can i check vortex shedder bar it is ok? if there is ohms condition are shown correct?
hi sir yhis is zahid ali i am preparing for the jspl at oct.4.please send me the recently updated sample paper.
How to Calibrate Radar Level Transmitter in Field
our kks tagging is crossing more than 12 character please suggest how to take tags in the DCS
what is the difference between attemperator and desuperheater ?
Is there any relation between Artificial Intelligence and Instrumentation?
what is controlling card in dcs? how u measure dcs memory?what is bus in dcs?how u know dcs speed n ehternet speed?
Explain why use mmwc unit?
