Answer / pritesh

because transformer depends on voltage and current v*i not
a depend of how much power is transfer so thats why its
rating in KVA.

Answer / rakesh

because its power factor depend on the other load.

Answer / nagaraj .n (bush king)

because trasformer is connected to supply resistive lode
inductive lode &capaitive load .the power factor for those
load is different (lag or leding )it worked apperent power.
the unit of apperent power is volt-aamper.that why
transformer rated in kva.
(its my knowledge)

Answer / kishore

loss coming due to passing of voltage and current

Answer / lalu prasad jadav

because Transformer has Two winding.It becomes very hot
while in running condition.So a considerable amount of heat
loss occured.So the loss in Kw may vary.So Kw rating is
avoided and Kva rating is given in Transformer nameplate.

Answer / rajesh

transformer dosent consume power.it just step up/down the
voltage.thats why transformer mentioned in kva

Answer / sachin

While designing the transformer manufacturer dosenot know
the load power factor.

Answer / kishor a. thakkar

because its load is variable. and motor load is
continuously so we measure in KW. and Trans. measure in Kva.

Answer / naresh

The unit of voltage in Volts
The unit of current in Amperes
When the energy transfer from primary ciruit to secondary
circuit power is constant. there is no involvement of power
factor. Due to this transformer rating in KVA not in KW

Answer / amol

The instruments which converts energy from one form to
another, rated in KW like motor etc which keeps same form
of energy will be rated in KVA like Transformer,stabilizer
etc

what is ht breaker

8 Answers  

can we run a motor rated 50Hz,415vac,1440RPM At higher speed then rated on name plate with the help of VFD /drive on long term basis.wheater it will effect the motor life

3 Answers  

plz send me the procedure and syllabus for mseb exam

0 Answers  

considering the 3phase and single phase ac system the load applied and the volage given is same...will the current differs for both the cases are it wil remain same?

5 Answers  

need to make a report. Need to choose a 3phase induction motor. Load conditions motor will operate in : Maximum Load: 30 Kw Speed: 2950 rpm Ambient temp: 20 cent Supply voltage: 440V Frequency: 50Hz need to look for the safety factor when choosing the motor, went through catalouge found a few, but dont know how to choose the safety factor allowing an extra load something above 30 KW to avoid any harm.

0 Answers  

what is meant by VFD ?where its useful ?

7 Answers  

upto how much low RPM we will run the commercial motor which is run through VFD without any problem occurs in motor.Motor rating Duty is S1 & RPM is 1400.

0 Answers   ABC,

What is the difference between AC Drive and VFD?

10 Answers   ITC Infotech,

What will be the capacity of the generator set which can be used for my 2 ton window air conditioner ?

1 Answers  

what is the standard values(Megger test) of resistances between L&N,L&E and N&E for a system on IEE regulations?

0 Answers  

Why derating factor os applied on Cables?

0 Answers  

What is OT in a transformer, specify its function.

2 Answers