Answer / gerald francis suresh

noise and distortions are very low because single channel
means, i hope that is single video broadcasting, any kind of
video has only the frequency of 0-5Mhz, multichannel will
affect the reliability of the communication. or the
communication should be multiplexed with frequency, time or
phase.

Answer / gerald francis suresh

noise and distortions are very low because single channel
means, i hope that is single video broadcasting, any kind of
video has only the frequency of 0-5Mhz, multichannel will
affect the reliability of the communication. or the
communication should be multiplexed with frequency, time or
phase.

Answer / karuvesh sharma

In SCPC the noise,distortionconjuction are very low as well
as the possibility of croos talking is not happen

sir i am completed B.E in 2006 i wrote RRb Section Engineer Exams two times .how to prepare and how is ask previous question paper some previous question paper send through mail id

2 Answers   RRB, Spectrum,

---

What is the state if the RED LED is glowing on PWSx card What is the state if the YELLOW LED is glowing on PWSx card

0 Answers   NSN,

---

What is the mechanism by which conduction takes place inside the semiconductor?

0 Answers  

---

11. BCSU card in BSC can support how many TRXs? 12. What is the command to check list of sites that are down?

5 Answers   NSN,

---

State different methods of voltage control inverters. Describe about pwm control in inverter?

0 Answers  

---

---

what is the configuration of 1+1+1?

0 Answers  

---

why use -48 volt DC power in telecom?

5 Answers  

---

why is the threshold voltage of PMOS transistor negative

1 Answers   Reliance,

---

send me cutoff of surat nit for m.tech

0 Answers   NIT,

---

what is the full form of embedded system

2 Answers  

---

What is noise in modulation?

0 Answers  

---

Which channel is used for SMS?

3 Answers  

---