Answer / muhammad tahirkhan

inharite capcitors are to be formed b/w transmition lines
due AC current.because due AC current self endection is to
be done.and indue voltage and current also produce and as
ve we know that air act as a di-electric).so capciters
have been formed.
and those capacitor's voltage also to be added at reciving
end.and so we have greater voltage at reciving end rather
then sending end.

Answer / chide dilipkumar

sending end voltage is more than recieving end voltage at
no load or light load conditions, due to which all our long
transmission lines are connected in parrallel to the
capacitance bcoz most of our loads are inductive...nd when
ever the load is off, the charging current stored in the
capacitor will allow through the line of which it increases
sending end voltage..., also the resistance at the sending
end voltage is lower than the resistance at the recieving
end, as V=I(R+jX) there is a drop in the voltage

Answer / abdul samee

because between the line and earth a series of capacitors
is form to which line is charge and discharge continuously
under light or no load condition,which in subsequent that
voltage at receiving is higher than sending.

Answer / moazzam shehzad

At no load or at light load inherent capacitance of
transmission lines produces lagging power in system that
produce an increase in the out put voltage than the input

Answer / john

Due to the power loss.

how do skin effect is reduced when hallow cond or stranded cond are used ?

1 Answers  

temp of cast resin 1500kva tx formerwent up to 138.c but came down very fast to about 100.c within 20 mins when load was reduced from 70% to 60%

0 Answers  

ceiling fan wattages rating

1 Answers  

What will be MF for below rating ? Main CT PT value is 11kva/110 and 20/5 amp Meter display is 1kva/110v and -/5 amp What will be MF ? Multiplycity factor of energy meter

0 Answers  

what is ASCR cable and where we use it?

6 Answers   BSL,

why the power factor in inductive load is lagging while it is leading in capacitive load?

6 Answers  

state the disadvantages of carbon filament???

0 Answers  

In case of HV test on medium voltage cables, BS is asking for 4 U0 where as IEC is asking for 3.5 U0. Can any one advise me how this 3.5 times or 4 times U0 is derived?

0 Answers  

What is the Efficiency in Electric motor ?

2 Answers  

What will happen if DC supply is given on the primary of a transformer?

6 Answers  

If stator & rotor of a 3-phase induction motor have different no. of poles, will the motor run or not??

3 Answers  

where is the primary of CT??

3 Answers