What is induction motor

1 Answers   Indoco Remedies,

---

I have a question, I visit 01 site and face a problem, there is 2.5 ton Air Con working, when air con compressor is running at that time rectifier voltages are increasing upto 290-295 v and rectifier is giving main high alarm (rectifier is APC single phase), before starting compressor rectifier voltages was 230v. when air con is going off rectifier voltages are decreasing smoothly at its actual voltages 230v. Load on Genset phases is this: Red-13.5 amp AC (Air Con load), Yellow-1.7 amp AC (BTS lights etc.) and Blew-4 amp AC (telecom system load), Genset phase to phase and neutral to phase voltages are also ok. These are 10 sites having same system and same rectifier APC brand at every site 02 genset are working but the problem is same at all these 10 sites. What will be the reason behind???

1 Answers  

---

what happens when a power transformer neutral earthing broken???

11 Answers   MacLellan,

---

what is difference between VAT & CST

1 Answers   MIT,

---

In transformer how measure the winding temperature ?

5 Answers  

---

A transformer is used to light a 24volts,70watts lamp from a 240a.c main.The current in the main cable is 0.35A. Calculate, (1) The efficiency of the transformer. (2) the current in the lamp.

1 Answers  

---

what are the insulation properties.

2 Answers   Cable Wireless, MAHINDRA,

---

We know that, in case if there is a faulty insulation,or sc, the current is bypassed to earth through the earth wire that has low resistance.Actually, what will happen to that current that flows through gnd?In that case,if we come in contact with that faulty appliance, wont that current flow through us as we form a closed path by standing in gnd?Is grounding a safety measure?

3 Answers  

---

What is servo motor and what are different types of servo motor

0 Answers   BARC, Vipul,

---

dc supply given to dc generator winding.how is possible? my knowledge is saying the winding will burn. please reply.

0 Answers  

---

What id difference between power and energy?

0 Answers  

---

my 10 hp submersible pump is tripping when connected through ELCB.I have checked the megger value of the coil's with body.It was found to be 0.2mega ohm.that is leakage is there.But when connected to mccb it is not tripping.no leakage current in the motor.Is it safe to connect to mccb? what are the problem's will arise if future?also tell me in ELCB no neutral is connected to motor.than how ELCB was working?

1 Answers  

---