substance is flowing in a pipe of 200 mm inside cylinder diameter ot an average velocity of 3m/sec. At a given section of the pipe line the pressure is 1.5 MN/m² absolute. what is the flow work of 0.5 cubic meter, expressed in joules passing through section?
(a)1J, (b)75000J, (c)90000J, (d)25000J
if C.R increases then detonation will increase or decrease
heat transfer by radiation can be increased by?
What is the meaning of probe in Boilers and that stuff?
What is the detailed meaning of automotive clutch endurance test and inertia test?
Why not connect impeller shaft directly to motor shaft bypassing the stuffing box?What is the purpose stuffing box? Is there any pressure on the stuffing box?
current rating of a 3 phase dg set is 20 amp, but what will be the per phase current for single phase supply?
why screw pump are used insteed of centrifugal pump?
in a cylinder filled with any gas,if we attach two pressure gauges one at bottom and one is at top. will both pressure gauges have same reading???
how a disel engine works in generator? explain with labelled diagram?
what is draft and draft loss?in a boiler,how is draft created?
In d thermal power plant why D/A placed on height.
dear sir i m anshul kumar from dehradun i want to last five year railway chandigarh and allahabd entrance exam papers pls send it on my id my id is anshuldhiman83@gmail.com or anshuldhiman@rediffmail.com i shall be very greatful to u thank u
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)