substance is flowing in a pipe of 200 mm inside cylinder diameter ot an average velocity of 3m/sec. At a given section of the pipe line the pressure is 1.5 MN/m² absolute. what is the flow work of 0.5 cubic meter, expressed in joules passing through section?
(a)1J, (b)75000J, (c)90000J, (d)25000J
- 1 Answers
- 3016 Views
- I also Faced
- E-Mail Answers
Answer Posted / abrar malik
75,000 J
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
i want technical question of mechnical for rrb mumbai
I'm a Mechanical Engineer (2007 passed out) 77% distinction degree holder from anna university chennai, tamilnadu. presently working in a software company, i'm interested in getting my job with Indian Railways. Can any one help me in how to know the vaccancies and applying for RRB.
Distinguish between creep and fatigue.
What are the causes of I.O. high temperature in a diesel engine?
which type of que can be asked in this company?
What is torque converter?
sir,iam member to your gk books for one year plan,i have recived every months.i request you i want techical questions pls send as soon as possible
At 50 Centigrade (Fuel oil) what is its cast?
1) Any pipe line working fluid may water / steam on it one manual isolation valve suppose one side of valve 6 kg/ cm^2 pressure (i.e. up stream) and other side is “ 0” kg/ cm^2 pressure(i.e. down stream) . So how much Tourqe required for opening the valve in terms of Newton force wheather normal man can open this valve. (for reference pipe nominal bore is 100 NB )
Plese give us information Service Special Tools for Hydraulic,Trasmission,Main clucth,Rear axle etc for Mahindra Tractor 6030-4WD,Like SST Number,Discription,Price and Dimension or Photograph if u have.Thanks
what is the use of vacuum balancing valve in CEP
Which two elements have same percentage in proximate and ultimate analysis of coal?
sir, i need some help by you. sir i want to know there are any industry that give six month training on the basis of entrance examination. sir if there are any .pls send me ans on my email-id sk12005@rediffmail.com pls.
why stress relieving of stainless steel is not preffered
Why cad cam is better field against IT field?Is the salary is good in this field and if it so then what is the average salary in this field because I don;t think that salary is good enough in this field.
