There is a process in Frame-Relay where LMI resolves an IP address from a DLCI number. What is this called? A.) arp B.) inverse arp C.) rarp D.) automap E.) reverse arp F.) arp

2 Answers  

---

CPE is an acronym for which of the following? A.) Customer Premise Equipment B.) Central Processing Engineering C.) Customer Process Equipment D.) Central Processing Equipment

2 Answers   Cisco,

---

The network portion of an address typically represents a: A.) Router B.) Ethernet MAC address. C.) Computer D.) Host E.) Segment

3 Answers  

---

Identify the purpose of ICMP? A.) Avoiding routing loops B.) Send error and control messages C.) Transporting routing updates D.) Collision detection

2 Answers  

---

Which statement about the Point to Point Protocol (PPP) is true? A. PPP supports TCP/IP but not Novell IPX B. PPP is being phased out of existence by the Serial Line Internet Protocol (SLIP) C. PPP providces router to router and host to network connections over both synchronous and asynchronous circuits D. PPP is an ITU T and ANSI standard that defines the process for sending data over a packet switched data network (PSDN)

2 Answers  

---

Identify the named IP access-list number range? A.) 600 - 699 B.) 1 - 99 C.) 900 - 999 D.) 200 - 299 E.) none of the above

2 Answers  

---

Identify the 2 commands that will display the status and information about interface E0 only? A.) show interface ethernet E0 B.) show interface E0 C.) show E0 D.) show int E0 E.) show interface

1 Answers  

---

What is Cisco register bits? How they help?

1 Answers   jetking,

---

How does a switch use store and forward? A.) By using a Class I repeater in a collision domain B.) The LAN switch copies the entire frame into its onboard buffers and then looks up the destination address in its forwarding, or switching, table and determines the outgoing interface C.) By using broadcast addresses as source addresses D.) The switch waits only for the header to be received before it checks the destination address and starts forwarding the packets

1 Answers  

---

If a router uses static routing, how does it learn the route to remote networks? The router uses a RIP request to obtain remote network numbers. The router uses a routing protocol to exchange remote network numbers. The router uses DNS request packets to obtain remote network numbers. The Network Administrator manually configures the remote networks.

1 Answers  

---

How many valid ip will b in /21 in route summarization?

0 Answers  

---

hello sir , if i finish this certification is the job is conform ?? and in chennai were i can do this ??

1 Answers  

---