Interested to Buy Any Domain ? << Click Here >> for more details...
Identify the 2 commands that will display the status and
information about interface E0 only?
A.) show interface ethernet E0
B.) show interface E0
C.) show E0
D.) show int E0
E.) show interface
- 1 Answers
- 3882 Views
- I also Faced
- E-Mail Answers
Identify 2 transport layer protocols? A.) IP B.) TCP C.) CDP D.) ARP E.) UDP
Which commands would assign and enable IPX on an interface ? A.) enable netware B.) enable novell-ether C.) router#(config)ipx routing D.) You must first enable IPX globally and then assign the network number to the interface . E.) enable ipx F.) router#(config-if)ipx network 4a
When determining whether or not to route a LAN segment, which rule of thumb do you use? A.) 60/40 B.) 50/50 C.) 80/20 D.) 90/10 E.) 70/30
What is the igp (interior gateway protocol)?
At what layer of the OSI reference model does FRAME-RELAY map to? A.) Session B.) Physical C.) Network D.) Presentation E.) Transport F.) Datalink
What do we check while configuring the server?
What is the maximum hop count for Link-State protocols? A.) 15 B.) there is no hop count limit C.) 256 D.) 16
Which 2 protocols are in wan technology?
Explain how many broadcast domains are in switch?
Identify 3 characteristics of switches? A.) Increase available bandwidth B.) Decrease broadcast traffic C.) Support full duplex in a multipoint topology D.) Make forwarding decision using MAC address E.) Create collision domains
Which command displays the intenances using a given access list? A. show filters B. show ip interface C. show active lists D. show interface paramaters E. configure ip access lists F. show access-list interfaces
How IEEE Calculate the Cost of Link (ex.. 10mbps is having Cost 100) Is there any formula or any test to calculate it.
CCNA 
