Interested to Buy Any Domain ? << Click Here >> for more details...
The network portion of an address typically represents a:
A.) Router
B.) Ethernet MAC address.
C.) Computer
D.) Host
E.) Segment
- 3 Answers
- 9657 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / guest
Answer: E
Every network segment is represented by a network or
subnetwork address.
| Is This Answer Correct ? | 7 Yes | 1 No |
Answer / zibrayal.s.mulla
may i please get the answer in brief please sir...?
| Is This Answer Correct ? | 0 Yes | 0 No |
What is the Cisco name for the encapsulation type used on a serial interface? A. HDLC B. SDLC C. SAP D. SNAP
Identify the command to display the configured IP routing protocols? A.) show protocols B.) show protocols all C.) show routing-protocols D.) show ip protocols
EIGRP send query reply & Acknowledgment on which address ?
In regards to the ISDN BRI standard, which channel is used for control? A.) B B.) D C.) E D.) I E.) Q
A network is vow congested currently all the devices are connected through a hub. Which would best decrease congestion on this network? A. add a second hub B. replace the hub with a router C. replace the hub with a switch D. replace the hub with a repeater
Identify the statement which connects access-list 101 inbound to interface e0? A.) Router(config-if)# ip access-group 101 in B.) Router(config-if)# ip access-group 101 C.) Router(config)# ip access-group 101 e0 in D.) Router(config)# ip access-group 101 e0 in
What is the Broadcast MAC Address?
An autonomous system can only exist if all routers in that system meet which criteria? A. interconnected B. run the same routing protocol C. assigned same autonomous system number D. run IGRP only E. run RIP only
Identify the command to display all the valid commands at the given mode? A.) Help all B.) Help C.) All commands D.) ?
Explain how many broadcast domains are in switch?
what is vlan and how will you configure vlan on 3650 switch and how many valn can you create on that switch
If you are in IOS user mode, which command do you use to enter the privileged mode? A. Set B. Enable C. Configure D. Privileges
CCNA 
