Interested to Buy Any Domain ? << Click Here >> for more details...
Which statement about the Point to Point Protocol (PPP) is true?
A. PPP supports TCP/IP but not Novell IPX
B. PPP is being phased out of existence by the Serial Line
Internet Protocol (SLIP)
C. PPP providces router to router and host to network
connections over both synchronous and asynchronous circuits
D. PPP is an ITU T and ANSI standard that defines the
process for sending data over a packet switched data network
(PSDN)
- 2 Answers
- 9367 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / rams
C. PPP providces router to router and host to network
connections over both synchronous and asynchronous circuits
| Is This Answer Correct ? | 2 Yes | 0 No |
What is the maximum request timer?
Which command we give for live view of remote site routers?
Identify the mode reflected by the following prompt 'Router'? A.) Setup B.) RXBoot C.) Boot mode D.) Privileged exec mode
Which Standard IP Access list commands will deny only the source address 1.1.1.1? A.) access-list 9 deny host 1.1.1.1 B.) access-list 9 deny 1.1.1.1 255.255.255.0 C.) access-list 9 deny 1.1.1.1 0.0.0.0 D.) access-list 9 deny 1.1.1.1 0.255.255.255 E.) access-list 9 deny 1.1.1.1 255.255.255.255
Identify the command to determine if CDP is enabled? A.) show enable cdp B.) show cdp enabled C.) show cdp run D.) show cdp
The Cisco Discovery Protocol (CDP) periodically sends out a multicast packet (at layer 2). Which command will alter the default interval of 60 seconds? A.) cdp hold 111 B.) cdp wait 111 C.) cdp interval 111 D.) cdp 111 E.) cdp timer 111
hello sir , if i finish this certification is the job is conform ?? and in chennai were i can do this ??
Identify 3 feature of access-lists? A.) Implicit deny will deny any packets not matched B.) Processed sequentially from bottom to top C.) Processed sequentially from top to bottom D.) If a packet is denied it would be tested against the remaining statements in the access-list E.) Once a match is made the packet is either denied or permitted F.) Enabled on all interfaces by default
In how many ways can data be transferred in ccna?
What does the IPX maximum-path command do? A.) Allows you to disable the TTL on an IPX packet B.) This parameter is only used in NLSP routing C.) Sets the maximum metric that can appear in the routing table D.) Configures round robin load sharing over multiple equal metric paths (parallel paths)
What must be true for two routers running IGRP to communicate their routes? A.) Same autonomous system number B.) Connected using Ethernet only C.) Use composite metric D.) Configured for PPP
You have just issued the erase startup-config Command and reloaded your router. In which mode will your router be when you react? A. setup B. startup C. user EXEC D. userd privileged E. global configuration
CCNA 
