what are the 3ree way for implementing vlan on cisco switches what is the layer hierarchy of the cisco what is the best place of implementing standard access list what is q stand for isdn these are the challanging question for me i am waiting for jitendera sinha answer(it is challenge for u i have seen lots of answer given by u )it is a challenge in the frendshipmode plz donot take other wise

2 Answers  

---

Which cable called roll-over?

0 Answers  

---

Identify the command to display the hardware platform information? A.) show all B.) show platform C.) display hardware D.) show version

1 Answers  

---

Identify the 2 commands that will display the status and information about interface E0 only? A.) show interface ethernet E0 B.) show interface E0 C.) show E0 D.) show int E0 E.) show interface

1 Answers  

---

Which three commands are used to configure information into RAM on a router? (Choose three) A. configure memory B. configure terminal C. configure overwrite D. copy tftp startup-config E. copy running-config startup-config F. copy startup-config running-config

8 Answers   HCL,

---

Identify the components in the following command 'interface serial0/1/1' A.) Serial interface, port number 0, slot 1, port adapter 1 B.) Serial interface, slot 1, port number 1, port adapter 0 C.) Serial interface, slot 0, port adapter 1, port number 1

2 Answers  

---

from last ten days i watched that no any new questions are placed in ccna catogarey.so plz place the questions it is very use full to beginers like us

2 Answers   HCL,

---

As a system administrator, you perform an extended ping at the privileged EXEC prompt. As part of the display, you see "Set DF bit in IP header? [yes] :" What would happen if you answered no at the prompt. A. This lets the router fragment the packet. B. It tells the router not to fragment the packet. C. This lets the router direct the packet to the destination it finds in its routing table. D. It tell the router to send the packet to the next hop router.

1 Answers  

---

The command 'debug ip rip' will do which of the following? A.) Show Neighbor Info. B.) Display RIP routing updates. C.) Show routing table changes. D.) Show all IP traffic. E.) This is not a valid router command. F.) Cause the router to respond with 'Ambiguous command'

1 Answers  

---

How many broadcast domains are in switch?

0 Answers  

---

Identify the command to determine if CDP is enabled? A.) show enable cdp B.) show cdp enabled C.) show cdp run D.) show cdp

2 Answers  

---

Which cable called v.35?

0 Answers  

---