1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.

0 Answers  

---

What is current and voltage?

5 Answers  

---

What is precision of a measurement?

0 Answers  

---

What are the difference between normal application Transformer and Solar application Transformer?

0 Answers  

---

why power dissipation is due to low frequency?

1 Answers  

---

the grid connection required for a 50 MegaWatt fotovoltaic powerplant is higher or lower than 35kv (high or medium tension)?

0 Answers  

---

show that power dissipated by a pure inductor exited by a sinusoidal voltage source v = vm sin wt is zero

1 Answers  

---

What are the solutions for avioding sulfide formation at bimetalic (Copper &Aluminium)overhead joints?

2 Answers   HAL,

---

draw the block diagram of fire alarm?

0 Answers  

---

What is the difference between SSR drive& AC drive?

1 Answers   ITC Infotech,

---

what is the design factor that affects the size of a motor ?

3 Answers   Reliance, SGI,

---

What is the basic difference between synchronous machine and induction machiine?

1 Answers  

---