Dear Brother can u tell the proper size selection of cable &
the fault level calculation of braker, busbar etc.
pls mail me at azeemk30@gmail.com
No Answer is Posted For this Question
Be the First to Post Answer
In parallel operation time both NGR’s close or not close if both close what will happen
what is mean by unity power factor?why are u calling Resistivity load also unity power factor?
Where can i get practical knowledge of solar system?
Which thing is maximum in RLC circuit at resonance a)power consumption b)inductive current c)capacitive voltage
What is the difference between Earth and Neutral?
I have 2 Nos of 2500kVA 33/0.415V cast resin transformers. How to decide on ampere rating of HT Panel? Also advise me how many panel RMG i have to consider whether 4 panel ok?
Multi-step core is used in transformer to: A) Increase the output B) Decrease the cost of core material C) Decrease the cost of copper D) Increase the efficiency
How CFL &T5 tube light glows?
how to copy from plc ge fanuc versamax series,all input and output, adress, and printout.
why we use dc motor instead of ac motor?
what is ht breaker
What conditions are required for transformer to operate at low frequencies ?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)