Which range of possible numbers do standard ipx access lists have? A. 100 199 B. 600 699 C. 800 899 D. 1000-1099

1 Answers  

---

What is the function of DDR on Cisco routers? A. DDR is dial--on-demand routing. It provides a continuous LAN only connection. B. DDR is dial-on-demand routing. It provides routing for high volume traffic. C. DDR is dial--on-demand routing. It provides a continuous WAN connection. D. DDR is dial-on-demand routing. It provides routing for low volume and periodic traffic.

2 Answers  

---

What is mtu and what is its size for transmission?

0 Answers  

---

Which is true regarding store-and-forward switching method? A.) Latency varies depending on frame-length B.) Latency is constant C.) It is default for all Cisco switches D.) It only reads the destination hardware address before forwarding the frame

1 Answers  

---

Of the following switching types, which one has the lowest latency? A.) Cut-through B.) Fragment Free C.) None D.) Store-and-forward

3 Answers  

---

---

6. Which device can create smaller networks and stop broadcast storms by default? A. Repeater B. Bridge C. Router D. Gateway

4 Answers  

---

Cisco routers use wildcard masking to identify how to check or ignore corresponding IP address bits. What does setting a wildcard mask bit to 0 cause the router to do? A. It tells the router to check the corresponding bit value. B. It tells the router to ignore the corresponding bit value. C. It tells the router to check its alternate routing list. D. It tells the router to use its primary routing list.

2 Answers  

---

what is flow control,.

4 Answers  

---

If configuring a Cisco router to connect to a non-Cisco router across a Frame Relay network, which encapsulation type would you select? A.) Q933a B.) ISDN C.) IETF D.) CISCO E.) ANSI

1 Answers  

---

What are the different layers of osi model?

0 Answers  

---

Which feature of PPP (Point to Point Protocol) allows the router to bind multiple channels together, to form a single logical channel? A.) multi-link ppp B.) multi-channel ppp C.) can't be done D.) omni-ppp E.) plp

1 Answers  

---

How often does IP RIP send out routing table updates by default? A.) They send complete updates every 30 seconds B.) They send partial updates every 30 seconds C.) They send complete updates every 60 seconds D.) They send partial updates every 60 seconds

1 Answers  

---