Identify the purpose of the TCP 3 step handshake? A.) Setup a un-reliable connection B.) Initialize routing tables C.) Synchronize sequence numbers between hosts D.) Connection tear down process

1 Answers  

---

Identify the purpose of the Trace command? A.) Explorer packet transmitting routing information B.) Test connectivity C.) Determine the path a packet is taking through the network D.) Transmits user data when buffers are full

1 Answers  

---

Can anybody tell me how to configure a cisco router?

2 Answers  

---

Describe ICMP messages

4 Answers   HCL,

---

thnx jitender...its me shridh...m working for SG ltd..the situation iz like ths -at a specific time in our company the internet connectivity goes off...v hav two networks in our company...but out of it only one link goes down for 5-10 sec...a fastethernet port becomes down for few sec and automatically becomes Up... Is this occures becoz of Power?? If yes thn y the 2nd network is not affected?? plz tel me jitender how to resolve ths problem? as u sd loop in switch is the primary cause of ths....i wanna know how to resolve it...thnx for ur replys jitender sinha.

2 Answers  

---

---

The two sublayers of the IEEE Data Link Layer are which of the following? A.) Link and Logical Control B.) Data Link and LLC C.) Logical Link Control and Media Access Control D.) Data Link and MAC

2 Answers  

---

Name the different types of networks

0 Answers  

---

What is the function of DDR on Cisco routers? A. DDR is dial--on-demand routing. It provides a continuous LAN only connection. B. DDR is dial-on-demand routing. It provides routing for high volume traffic. C. DDR is dial--on-demand routing. It provides a continuous WAN connection. D. DDR is dial-on-demand routing. It provides routing for low volume and periodic traffic.

2 Answers  

---

Given the following IP address from the Class C address range 192.168.21.12. Your network plan needs addresses for 28 small prkps Each office uses its own shored. The network design specifies that you confound for five bits of subnetting. When you confound for this in Cisco IOS software which shored mask should you use? A. 255.255.0.28 B. 255.255.255.0 C. 255.255.255.28 D. 255.255.255.248 E. 255.255.255.252

1 Answers  

---

Difference between subnetting & Vlan??

7 Answers   Cisco, TCP,

---

here is your question sahin Hi Jitendera, If i m not wrong, then in EIGRP, Metric weight is set to K1(Bandwidth)=1, K2(Delay)=0, K3(Reliability)=1, K4(Load)=0, K5(MTU)=0. This is default setting for EIGRP. I knew about it from ICND 2 cisco press book. Three more questions - a) If we change the K value (I mean metric weight)on a router what will happen??? b) When redistribution is necessary in EIGRP. Is there any condition for that??? c) What is reference bandwidth for metric calculation in EIGRP. As we know, in OSPF, on a CISCO router reference bandwidth is 10Mbps.

3 Answers  

---

Identify 3 characteristics of an IP address? A.) Contains a network portion and a host portion B.) 32 bits long C.) Unique to each network D.) Part of the default Cisco configuration E.) Referred to as the hardware address

6 Answers   Infosys,

---