Which layer hides details of network dependent information from
the higher layers by providing transparent data transfer?
A.) Transport
B.) Physical
C.) Data Link
D.) Session
E.) Application
F.) Network
- 1 Answers
- 6217 Views
- I also Faced
- E-Mail Answers
Answer / guest
Answer: A
The Transport layer does the following: Responsible for
end-to-end
integrity of data transmission. Handles multiplexing upper-layer
application, session establishment and tear down of virtual
circuits.
Hides details of network dependent info from the higher
layers by
providing transparent data transfer. The 'windows' works at
this level
to control how much information is transferred before an
acknowledgement
is required.
| Is This Answer Correct ? | 3 Yes | 0 No |
Identify the type of hardware required to connect a Token ring network to an Ethernet network? A.) Repeater B.) TR-Enet C.) Router D.) Token Ring to Ethernet translation hub
Explain how many tables are in ospf protocol?
When we use router?
Which statement about half duplex Ethernet operations is true? A. With half duplex transmission frames feed into a single cable in one direction at a time. B. Half duplex transmission between stations is achieved by using point to point Ethernet and Fast Ethernet connections C. Half duplex transmission between stations is achieved by using point to munificent Ethernet and Fast Ethernet connections D. Half duplex Ethernet technology provides a transmit circuit connection wired directly to the receiver circuit at the other end of the connection
Identify the 2 characteristics regarding MAC addresses? A.) Contains a network portion and host portion B.) Always assigned by System Administrator C.) 48 bits long D.) Contains a vendor code and serial number
What s the formula for metric of ospf?
Write out a config to permit only the below MAC address to pass traffic through a port on your switch. in another way writhe a confrigation which permit only mac address trfaic through a port of your switch
What is public and private ip address., explain? and also explain the ip address range of both public and private? and where we use that public and private ip address?
What are the protocol data units (pdu) in ccna?
Which of the following are characteristics of UDP? A.) UDP is connection oriented. B.) UDP is used with TFTP. C.) UDP is unreliable. D.) UDP is connectionless. E.) UDP is at the transport layer. F.) UDP uses no acknowledgements.
What does aaa stands for?
Do we subletting of ip?
CCNA 
