Identify the 2 commands the saves the running-config to NVRAM?
A.) write memory
B.) copy running-config startup-config
C.) write network
D.) write backup
Answers were Sorted based on User's Feedback
Which three basic switch functions increase available bandwidth on the networks? (Choose three) A. loop avoidance B. address learning C. hop count limiting D. broadcast filtering E. packet forward/filtering F. broadcast packet hop count learning/forward/filtering
IP extended access lists use which of the following as a basis for permitting or denying packets? A.) destination address B.) all of the above C.) protocol D.) source address E.) port
What is the maximum number of subnets that can be assigned to networks when using the address 172.16.0.0 with a subnet mask of 255.255.240.0? (Assume older version UNIX workstations are in use.) A. 16 B. 32 C. 30 D. 14 E. It is an invalid subnet mask for the Network.
Can we write any script for router to instruct that from where it will boots e.g. TFTP,FLASH...if yes what is it and how? 1 of my frnds says its possible...
What is an advantage of local area network (LAN) segmentation? A. smaller collision domains B. elimination of broadcasts C. decreased cost of implementation D. larger number of users within the same domain
Wnat do you know about zenpeck
HI friends. i need a suggestion and looking towards you foryours valuable suggestion friends i have completed ccna now i want to done red het linux system admnistration and networking i am liitle bit confuse betwwen them which one is better for me for job point of view reply soon waiting for your reply
Novell NetWare has an Ethernet frame type called Ethernet_II. What is the matching Cisco command line keyword for this encapsulation method? A.) dix B.) sap C.) arpa D.) gns E.) snap F.) novell-ether
Where is the point between the customers site and the phone carrier that responsibility changes? A.) CO B.) Demarc C.) DCE D.) DTE E.) CPE
hi friends i have some problem regarding technical round ahr round plz tell me what should the right answer technical questions 1 what is brouter 2 what is the menaing of 10 base2, 10 base 5 and 10baset 3 what is diffrence between bit rate and baud rate. and this question was tooooooooooo much difficult to me that hr said to me that rank me after the taking the all short of interview
What 2 commands verify end to end communications? A.) Trace B.) debug ip session C.) Ping D.) Route
Which memory component on a Cisco router contains the dynamic system configuration? ROM NVRAM Flash RAM/DRAM