Answer / b. salazar

Motors pull a very high current when they first start. This is due to the induced magnetic field building up to a point where it can begin pushing the rotor away from the stator's magnetic field. This is called locked rotor current. This current should drop off as the rotor begins to spin.

how do we calculate of transformer in va?what is calculation?

2 Answers  

---

why two contacts(in series) are using in closing circuit

3 Answers  

---

Form fator is the ratio of?

5 Answers  

---

how does electrical train works and what type of motors are used to drive the train? which level of supply voltage is used?

22 Answers   Alstom, Infotech,

---

An AC coil to give DC supply whats happen in the coil.what type of problem are create.

2 Answers  

---

---

In case of salient pole alternator when number of poles are 4 or more than 4 it helps the flux wave to be sinusoid as air gap length is increased from center to tip , but if the number of poles are 2 how does the flux wave is sinusoidal?

0 Answers  

---

What should be the values of settling time, peak time, steady state error, overshoot, rise time, MPOS (Maximum percent over shoot) to keep the system in transient state, to keep the system in steady state ?

0 Answers  

---

Dear sir,how should i set the relay in star delta starter..say ex i am having 4ohp motor,,wht should be the relay setting...?

4 Answers  

---

What is the settings of distance protection relay in 400 kv line

0 Answers   Crompton Greaves,

---

why the neutral of power transformer is always earthed?

1 Answers  

---

for measuring current and etc.,why we use value of 1.732 in three phase calculation. not in single phase.why

3 Answers   Bhel,

---

What is the basic rule for block diagram reduction technique?

0 Answers  

---