Answer Posted / b. salazar

Motors pull a very high current when they first start. This is due to the induced magnetic field building up to a point where it can begin pushing the rotor away from the stator's magnetic field. This is called locked rotor current. This current should drop off as the rotor begins to spin.

What about electrical Units. discrive in detail

2097

---

If we need4× 50mm sq cable but it's not available so we can pull 4×25mm sq 2cables

1480

---

If 22 KV HT line, Current transformer is 25/5 then how to calculate multiplying factor.

1092

---

How to reduce -234126219.6403 MVAr generation and by what?

1631

---

ACCORDING TO IEC WHAT SHOULD BE THE MINIMUM HEIGHT OF G.I. STRUCTURE OF CT, PT, ISOLATOR, LA?

2204

---

Explain with example of functional requirements of protection relay in terms reliability, selectivity, sensitivity

1886

---

How to test the vector group of a Yd11 transformer? what are the relations to be checked between various vectors to confirm this vector group?

4471

---

What happen when change order of CT in GIS feeder?

1651

---

If I want to replace a 26KW Slip ring Motor with a Squirrel Cage motor & Drive (for a Hoist Application). How can I approximate the Motor & Drive HP required in new Setup.

2273

---

how hazordious area is classified at an oil & gas plant and categorise suitable class of electric equipment in that area like induction motors, LCS, Lighting Fixtures Fluerescent/Flood lights Mercury& sodium lights, J.Bs, Power Cables etc

1845

---

what is the difference between gas group b and gas group c electrical equipment construction wise?

1870

---

How to calculate that clean water supply in one Day from 150 KLD STP?

2011

---

What current flows in the transformer primary when its secondary is open?

1257

---

can we use engine degreaser for electrical motors?

1764

---

Why we find the sensitivity for the CT's to check?

1866

---