Answer / supriya

In electronics, the form factor of an alternating current
waveform (signal) is the ratio of the RMS (Root Mean
Square) value to the average value (mathematical mean of
absolute values of all points on the waveform).
i.e.
Kf=RMS/AVERAGE

Answer / viendra

Form Factor = RMS Value / Average Value

Answer / ganesan govardhan

Hi,I am Ganesan Govardhan
Significance of form factor:
When an AC voltage is rectified by a full wave
rectifier,the DC value equals the Average value.
Having given the RMS AC input,we can find the DC output
from the relation

Edc = Erms/Form factor

Answer / dany

SUPRIYA, it is a good answer ,but can u clarify what is the
significance of this form factor

Answer / ponnu(the elite)

average value/rms value

Can anyone tell me how a 12v battery is transformed to 20,000v at the spark plug

6 Answers  

Which are Electrical componet and Electronics componet??

2 Answers   KarMic,

What is the difference between electronic regulator and ordinary rheostat regulator for fans?

0 Answers  

what is the difference between active power and reactive power and apparant power in practical as well as theoritical

0 Answers  

What happens instead of using 3 phase, if we give loop of single phase to all three phases ??

1 Answers  

how to deside the capacity of chock for drive?

0 Answers   Essar,

can any one tell me the formula to select the thickness of wire selection according to ampere rating

2 Answers  

in 220/132 substation in place of PT what equipment used & what r the role of that equipment

2 Answers  

Brushless excitation of synchronous generators and motors

2 Answers   AMIE,

the total iron closs in a transformer core at normal flux density was measured at 25hz and 5ohz and was found to be 250w and 800w respectively.the hysteresis loss at 50hz would be................?????

1 Answers   ABB,

How the over load setting for HT Motors calculated-provided in Numerical Relay

0 Answers   Damodar Valley Corporation,

Usage of flywheel diode in relays

0 Answers   Jindal, Voith,