Answer / sunil

Bundle conductor: 3 r 4 conductors in 1phase (eg.transmission lines voltage exceeds 220kv,
Double circuit:2 single circuit transmission lines in transmission

why the starting voltage drop in a cable needs to be limited?what is percentage of the voltage drop allowed during starting?

0 Answers  

---

why HT motors are earthed only at equipment side & for it's single core cable with aluminium wire armoure using?

1 Answers   Legrand, NLC Neyveli Lignite Corporation Limited,

---

our company have 750 kva oil transformer.still we have facing a problem that is when voltage is 11.5 kv coming from HT side then LT-side voltage is 420v or above at tape 1.please give me best solution to decrease the voltage.

3 Answers  

---

Is there a possibility to use such a treshold voltage for the NMOS part of a CMOS circuit that during the switching it will start conducting only after the PMOS part will be already closed, by this eliminating the leakedge current? Please note, I'm not asking about the well bias in standby mode, but about the "antileakedge" measures during normal operation.

0 Answers  

---

In generally how many earthing required for power

4 Answers  

---

---

Transformer TTR test procedure

2 Answers   Descon,

---

what is the diffrence between preventive maintinance corrective maintinance?

7 Answers   Siemens,

---

What is a formula to decide the size of the cable of the star delta motor ( From Contactor to the motor 2 runs )

4 Answers  

---

I have made a 3 phase thyristor full bridge rectifier. But at the moment it is working only for the half bridge operation. Both the half bridges are on operation separately but when i put it into full bridge operation the oscilloscope output is zero. I rechecked that the pulses are correct for each thyristor. what could be the possible reason for this?

0 Answers  

---

draw singleline diagram of star to delta and dol starters

0 Answers   JCP,

---

1000 W bulb takes 4.16 Amps at 240 volt then what will be the KWH & if i am using 1000 W bulb at 180 Volt the amps will be 5.55 then what will be KWH????????????????

2 Answers  

---

Why derivative controller is not used in control systems?

0 Answers  

---