a new 3ph induction motor doesn't rotates their ratted speed, why ?

Question Posted / satya rout (oeg rr)

2 Answers
3735 Views
Sail, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

a new 3ph induction motor doesn't rotates their ratted speed, why ?..

Answer / satya rout (oeg rr)

A new 3ph IM check some following stepssss.
1.check bearing status
2.winding insulation resistance
3.check earth leakage current
4.check supply connection input (RYB) =output(RYB) is same.
basically phase inter-change is main reason for rotets the bello speed

Is This Answer Correct ?

4 Yes

1 No

a new 3ph induction motor doesn't rotates their ratted speed, why ?..

Answer / ashok k

This is due to Slip also. Anther possible reason broken short circuited rotor ring or Rotor lamination may be broken.

Is This Answer Correct ?

1 Yes

0 No

Post New Answer

More Electrical Engineering Interview Questions

3 phase supply is there Total kw 100 howmuch cable put the load

3 Answers

Is there a possibility to use such a treshold voltage for the NMOS part of a CMOS circuit that during the switching it will start conducting only after the PMOS part will be already closed, by this eliminating the leakedge current? Please note, I'm not asking about the well bias in standby mode, but about the "antileakedge" measures during normal operation.

0 Answers

How can we Run three phase motor when only single or two phase supply is available ??

3 Answers

HOW TO CALCULATE THE APFC Panel Design

1 Answers

what is VSWR?

1 Answers

What do you mean by distribution transformers?

0 Answers

why dc series moter is not started at no load?

5 Answers IOCL,

A three phase load, around 4 km away from the 11/0.433KV distribution transformer (Neutral of Transformer is solidily earthed) and consisting of mainly very costly and sensitive electronic equipments is giving trouble due to high voltage difference between neutral and body earth. Whether this problem can addressed by connecting neutral at the load point solidly to earth?

3 Answers

hi friends ,iam working as genset AVR service engineer in electrical field from past 2 yrs throughout india . i plan to shift in some other job without travelling in same field because i con't travel,i dont know what i do for that so please guide me what job is suited for me,how i can serch the job please anybody helpme iam totally confused

0 Answers

Where voltage are high and current to be interrupted is low the breaker preferred is:

0 Answers

What is main purpose of chock coil and starter in florescent tube ?

1 Answers

what is the difference between online & offline caliberation of KWH meters. Can Digital meters be caliberated

0 Answers

For more Electrical Engineering Interview Questions Click Here