Answer / ali

M35 is a design mix concrete. ratio is depend on design calculation .

Which is stronger solid steel rod or hollow steel pipe?

0 Answers  

---

what is the density of fine sand grade-2

3 Answers  

---

what is meant by concrete joints?

1 Answers   NBCC,

---

WHAT IS THE LAP LENGTH FOR COLUMN WITH DESIGN MIX M-35 RCC

7 Answers   Omaxe, Shoba Devlopers,

---

How much is the cover for slab?

0 Answers  

---

How did the romans get water up hills using aqua ducts?

0 Answers  

---

How many solid blocks can build one mason per 8 hours?

1 Answers  

---

1.DIFFERENCE BETWEEN NOMINAL MIX AND DESIGN MIX? 2.WHAT IS MEANT BY STRUCTURAL DESIGN? 3.IN STAAD WHY WE RELEASE MOMENT TO A MEMBER? 4.ON WHAT BASIS PARTIAL FACTOR OF SAFETY ARE DECIDE?FROM THE LOAD COMBINATION? 5.WHY WE PROVIDE EXTRA BAR & DEVELOPEMENT LENGTH AT TOP? 6.FULL FORM OF SPT & SMB? 7.WHAT IS MEANT BY ITP IN A CONSTRUCTION PROJECT? 8.WHAT IS LEAST COUNT OF THEODOLITE SURVEY? 9.WHAT ARE THE CAUSES OF FAILURE OF FOUNDATIONS AND REMEDIAL MEASURES? 10.WHAT ARE THE VALUES OF COMPRESSIVE STRENGTH? 11.STEEL CALCULATION FOR FOOTING,BEAM & SLAB? 12.WHAT IS MEANT BY GANTRY GIRDER? 13.IN SITE HOW WE CAN IDENTIFY THE ONE WAY, TWO WAY SLAB? 14.DIFFERENCE BETWEEN ANCHORAGE LENGTH & DEVELOPEMENT LENGTH? 15.BEARING CAPACITY OF STEEL SHUTTERING?LOAD CARRYING FOR SHUTTERING?

3 Answers  

---

where you provide overlap on column?

10 Answers   ABB,

---

if 6.0M x3.0M Boat floating on water One person Sit on Boat Then the boat Sink about 15cm .Then what is the wt of person.

3 Answers  

---

What is the factor of safety in civil engineering

3 Answers   L&T,

---

if the slab is 2 way then,where we will put lapping upper and lower side?means near to beam or center and near to center?

2 Answers  

---