Answer / prem

accelero meter or displacement meter works on maintaining particular gap voltage. as long as gap voltage is adjusted and maintained in between -9 to -11 vdc. sensors are in healthy condition. If the sensors moved then positioned alarms will be available in HMI and its start permissive in most of the cases.

what is the diffrence between mmwc and kg/cm2 for pressure measurment when we are using mmwc and when kg/cm2 and why????? ?? what is the reason

19 Answers   Ecoboard, Jindal, Sepco,

---

What is limitation of the ht.of the displacer of a level trol?

0 Answers   CCIE,

---

what is the difference between CPC and i/p converter

1 Answers   Siemens,

---

How to adjust the zero & span of a control valve from the posiitioner(MIL)?

1 Answers   Bhel, SMC,

---

I am teja. I am studying Msc(tech) Electronics and Instrumentation (3years course) in Andhra university. But my course is not recognised by UGC and AICTE. Please tell me the job opportunities after this course. And i fineshed PLC course in IGIAT ,Vizag.Also complted my short term coure in SCADA, Seimans WinCC in ATI,Hyd.After Msc can i join Mtech for good job? or phd. How i can get good job in INdustrial Automation Side. Please give replay.Because this is my life matter.

0 Answers  

---

Introduce yourself which is not present in your biodata?

0 Answers   GAIL,

---

How to calibrate the magnetic flow meter and how to correct the flow if it is showing more flow.

5 Answers   Bohra Industries Limited, TCL,

---

How to calibrate radar lt type transmitter

1 Answers   NTPC,

---

What is ptw and write 3 types of ptw?

5 Answers   Emco,

---

How can we test a bently nevda 3500/42M accelerometer monitor card by simulating it with test equipment?. what king od of signal (milli volts or volts or or resistance ) we should feed in the terminals of the card?

0 Answers  

---

ABB DCS (AC 800 M)redundency take howmany milliseconds to switch from master controller to slave?should be less than DCS scanning time?

2 Answers   SCS,

---

what is the zero elevation and zero supresstion in level measurement, how can use it?

2 Answers   GAIL,

---