How to check it good or bad capacitor
Answers were Sorted based on User's Feedback
Answer / sheik farvat
one end of capacitor wire is connected to phase and another of the capacitor wire is connected to the neutral,then remove from the socket and touch the capacitor two wire (phase and neutral )if spark is coming is good or otherwise is bad
| Is This Answer Correct ? | 5 Yes | 0 No |
Firstly check out the rating of capacitor you want to check.According to voltage rating given on capacitor, apply the voltage to its two terminals(Note :Do not apply the voltage more than rating voltage,otherwise it will make a short circuit,less voltage can be applied) and then short those terminals.if spark between terminals is observed it is good otherwise it is bad.
| Is This Answer Correct ? | 1 Yes | 0 No |
Answer / l.chandrasekharareddy
How to the calculate kw in vfd motor
| Is This Answer Correct ? | 0 Yes | 0 No |
Do not give supply directly but through a bulb. It may be shorted or you may exceed the rated voltage . If the capacitor is good the brightness will be less and you can also test for stored energy
| Is This Answer Correct ? | 0 Yes | 0 No |
what is relation of rpm with Power supply? rpm directly Proposational to power ?
What are the three types of compensators?
What does OHB stand for in specifications for circuit breakers, especially found in SF6 circuit breaker?
In a Dyn11 transformer, how are the 3 windings of the delta connected? Assume that R1-R2, Y1-Y2, B1-B2 are the 3 windings on the HV side.
why insulators are colured in brown only?
What’s electric traction?
what is the difference between switchgear and circuit breakers and is there any difference between outdoor and indoor switchgear and circuit breakers , and how would you differentiate between switch yard and substation and grid station . thanks
kindly tell me how the load on generator increase by just increasing the fuel of prime mover, as if for exampple 20 MW gen set is synchronized the load ramps from zero to 20 MW gradully and during this procress only fuel of prime mover increases. Which thing determines the load on generator with respect to fuel
How to setting the volume of RTCC panel AVR (11kv) controller
0 Answers CNF Automotive India,
Which theory is used in the analysis of salient pole rotor synchronous machines? Who is credited for this developement? Could the same theory be used for cylindrical rotor synchronous machines?
What are protection of transformer on HT side & on LT side?
In star delta Schematic can we connect OLR in delta circuit
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)