Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / harishdarade563
Firstly check out the rating of capacitor you want to check.According to voltage rating given on capacitor, apply the voltage to its two terminals(Note :Do not apply the voltage more than rating voltage,otherwise it will make a short circuit,less voltage can be applied) and then short those terminals.if spark between terminals is observed it is good otherwise it is bad.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
EHV current carrying parts need to have smooth finish,then how can a 245kv GIS with emery finish can run so long?
HELLO EVERYONE, I RECENTLY HAVE FOUND ONE PROBLEM, I WAS TAKING NO LOAD TRIAL OF AN HT MOTOR 920 MOTOR , 1440 RPM , 6.6 KV, WITH AUTO TRANSFORMER. AT 450 V, LOAD WAS 40 AMP AND SPEED WAS 250 RPM. BUT AS WE INCREASE VOLTAGE FROM 450 TO 480V, LOAD BECOME 41 AND SPEED REDUCED TO SOME RPM . SO WHICH PHENOMENON ACTED HERE FOR REDUCING SPEED.?? AND IS IT HAPPENING ALWAYS OR IT IS RARE? I ALSO HAVE FACED SUCH PROBLEM WITH FEW LT MOTOR ALSO.
i want to apper for apgenco or aptransco or related can any one sugest me where can i get previous papers of thouse exams
what is the relation between knowing of the distance between power transformer and the capacitor feeder in case of parallel operation
In case of HV test on medium voltage cables, BS is asking for 4 U0 where as IEC is asking for 3.5 U0. Can any one advise me how this 3.5 times or 4 times U0 is derived?
How to calculate the no of Ceiling fan (1200mm sweep) per unit area?
What would be the size of wire used for 2 Ton of window A.C?
What happened when voltage will half value of current ...
Why we use ups battery and dsdb battery in thermal power plant
List of equipments required foe industrial repair lab.
what is the calculation method to design core and winding of a 200kva 3phase distribution transformer?
What is the tension required for the 25000 CFM AHU belt
how to interlock 3 incomer-ACB,1 buscoupler ACB,... pls answer this question and if possible send me the ckt diagram..haifriends2910@gmail.com
How is efficiency of DG set calculated? At many places I found the efficiency to be mentioned in percentage. But at some other places I found kWH/ litres. I want to know how dimensionless percentage value is arrived at?
Explain what is clipper and clamper circuits?
