Answer / jaya kumar

The main purpose of stirrup is to hold the primary reinforcement bars. They also prevent columns and beams from buckling. The stirrups get placed diagonally when there is tension and compression caused by vertical and transverse tension.

among fine,coarse sand which is used for plaster, brickwork and RCC & why?

2 Answers  

---

list out various type of codes:-

3 Answers  

---

yasser arfatcompleted his degree in civil from which university

0 Answers  

---

how to determine the foundation footing reinforcement spacing

0 Answers  

---

how to calculate shuttering measurement of beam and slab

3 Answers   NCCL,

---

How does siphoning work?

0 Answers  

---

IS code for Rolling Margin of steel

0 Answers  

---

why is M25 and Fe 500 assumed to be most economical? i feel it is not.This is because higher grade of concrete and steel has higher lapping length and anchorage length compared to lower grades..

0 Answers   CST,

---

on what basis the partial factor of safety are decided? form the load combinations

0 Answers  

---

the amount of gypsum usuallyin the manufacture of cement

12 Answers  

---

What is the wall thickness of NP-3&NP-4 hume pipe as per I.S code

0 Answers   Private,

---

02. a. The diagonal of a 9 cube…………… 1 b. Surface area of 9 cube…………… 1 c. Volume of 1-3 cube …………… 1 d. Compressive area of 6 cube …………… 1 e. Top & Bottom face of a Cylinder/Cube is to be proper leveled to deliver the…………………………..…… properly.

0 Answers  

---