Answer / sanjayjssate

the ground has always zero voltage with zero resistance, so if we connect any voltage it will draw huge current. But neutral has some resistance which balance the current flow .

Answer / ananda kumar barik

If we use ground at neutral it make unbalance load at distribution transformer which increase the voltage depending g the load .Low load has high voltage & high load has low voltage

Answer / k.prakashchandra

Earth resistance can not be made as low as that of conductor economically .

What is Harmonics how it is produced and what is the method to control the same

0 Answers   Siemens,

---

how is control wiring coding is done in a CRP panel ?

0 Answers   Genus, Havells, Hindustan Power Projects,

---

WHATIS TIME CONSTANT? WHATIS ITS SIGNIFICANCE? ILLUSTRATE THROUGH EXAMLES.

0 Answers  

---

I have a reading off 1.5ohms at my mem my main c/b is rated at 40/6 amps in a domestic house and i was told to change it to a b curve c/b is this ok

0 Answers  

---

How to calculate the NGR value for a 2.7MVA Transfomer, 11KV system where the fault current has to be limited to 50A?

1 Answers   Sterling Wilson,

---

what is earth-fault?when it occurs? to check where it occurs what type of test should we do?

0 Answers   ONGC,

---

What is mean CT Saturation? How to calculate?

13 Answers   NCC,

---

what are the advantages disadvantages of connecting high voltage block( 1:1 transformers) transformers between the turbo generators and busbars.

0 Answers   Bajaj,

---

why using eleven's multiple for substations?

2 Answers  

---

what is importance of ka in mccb

2 Answers   ABB,

---

we all know that corona is nothing but ionization of air around the conductor and there by allowing current to pass through ionized air.but we are not getting any short circuit in between the respective phases though the air turned as a conductive media between them??

1 Answers   Siemens,

---

what is Diversity factor in electrical installations

3 Answers  

---