Answer / cae

Ladder logic is one of the basic programming language in plc, In general we use electrical wires to do the control circuit of any equipment by connecting stop, start, timers or contactors etc..to control the output. on the same way if we want to control the motor action by PLC, we use ladder logic which is written in plc programme between two vertical lines called phase & neutral or bus bar. where we draw the lines by inserting NC, NO contacts by joining timers or counters or output coils which means a motor or any load which u want to control it.

what is the maximum current carrying capacity of a 95 sqmm cupper under ground cable laid partialy in land and partialy in ground?

4 Answers  

---

why AC voltage source are generate as 50 Hz ?

4 Answers  

---

Why current Transformer is rated by 100A/5A/5A?

3 Answers  

---

Why capacitor blocks DC current?

2 Answers  

---

what is bus PT ?

4 Answers  

---

What are the safety devices on Cumins Diesel Generators from 500 kva to 1500 kva.

1 Answers   Maruti Suzuki,

---

what is the difference b/w conductor and semicoductor

1 Answers  

---

What are the insulation standerds for eg H clase and how many insulation standerds are there and its standerds??????

0 Answers  

---

How to select the Cable size for 550 Amps Load without seeing the cable Catalogue?

8 Answers   Nesma,

---

How we calculate the current carriying capacity of the different sizes of Aluminium busbar ?

3 Answers   ABB, Raj Process Equipments, Visa Steel,

---

The unit of resistivity is:(a) ohms(b) ohm millimetre(c) ohm metre(d) ohm/metre

4 Answers  

---

how can we select the rating of Load break switch that is connected to the primary protection of 200 kva 11kv/415v distribution transformer?? step by step calculated answr pls...thnk.u

2 Answers   Maruti Suzuki,

---