Interested to Buy Any Domain ? << Click Here >> for more details...
What is the ladder circuit?
- 1 Answers
- 2947 Views
- Mitharg Information Systems, I also Faced
- E-Mail Answers
Answer Posted / cae
Ladder logic is one of the basic programming language in plc, In general we use electrical wires to do the control circuit of any equipment by connecting stop, start, timers or contactors etc..to control the output. on the same way if we want to control the motor action by PLC, we use ladder logic which is written in plc programme between two vertical lines called phase & neutral or bus bar. where we draw the lines by inserting NC, NO contacts by joining timers or counters or output coils which means a motor or any load which u want to control it.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
how can i find ct ratio of meter by seeing name plate of meter and how it should be used in MF calculation if it shows only-/1???
explain the what is a drive ? 0 4 which type motor r use in the celling fan..... PCB plannet 2 13 If stator & rotor of a 3-phase induction motor have different no. of poles, will the motor run or not?? types of drives Why dc supply is used for closing and tripping coil of ht breakers. What happen if we use only ups ac supply only. ACC 1 41 how the 3phase induction motor is running in 2phase supply with help of capacitor? 1 33 what is the actual difference betwen constructional details and constructional features? 1 20 how does commutator convert a.c to d.c?
What is float cum boost charging system?
What is the minimum distance to be maintained in between HT panel and LT panel and Instrument panel as per IEC and NEC standards?
how can we design robots
what will happen if i connect 12 volt battery with 24 volt battery charger.
Explain the following and how these are working with PLC Unit 1 I/O Module Card 2 Adaptor Card 3 Ribbon Adaptor 4 I/O bus 5 I/O Devices
could you measure current in parallel?
Is it possible to measure correct value of earth resistance & cable insulation ristance with out disconncting earth lead & both sides of cable ends? If not, any other method to measure ER & CIR with out disconneting from the system.
Dear sir, I have completed DECE in the year 1995. I have work experience in HT and LT LINE more than five years. Now i am doing BE in EEE from rajasthan university. After completion of BE,can i apply "C" Licence sir? Please reply.
What is electrical cable termination
Why the magneti fields are not passes from southpole to north pole
In the ACB breaker capacity is 2000Amp but this each phase taken 1250 But total beldibg load is 600amp or 700amp watt is the problem
What is transmittance?
if we have a industrial load of 400 kilowatts with 415 volt AC then how much total harmonic distortion (thd%) should be acceptable for steady power system.
