Answer / ramesh baraskar

PLC means Program logic control and DCS means distribution control system
PLC is limited I/O available and DCS system is no of I/O available.

How can we explain that what is the power factor?

5 Answers  

---

I am an electrical engg and has got selected in wipro should i go there now or try in some core company ?

3 Answers   Wipro,

---

An alternator is started without excitation then how much voltage it will produced at strating at full rpm??

4 Answers  

---

what is difference between DC and Ac

5 Answers   Birla,

---

What is the kiosk parts, about them and their functions ? If anybody have some PDFs files or details about this plz send it on tawhidfaisal@Yahoo.com

0 Answers  

---

When the DG is running at the time we can connect to capacitor banK? why it is required or not

1 Answers  

---

y we use neutral,all r told its used to for closed path..k its a just used to closed path,in a transmission line y we put same conductor used n both phase and neutral..if we use less than phase conductor in neutral mean we ll reduce cost its right r wrong..if we use mean any problem occur in transmission line..

0 Answers   ME,

---

in case of induction motor when overload condition or any short ckt. why stator winding burn not to be rotor winding

2 Answers  

---

In case of salient pole alternator when number of poles are 4 or more than 4 it helps the flux wave to be sinusoid as air gap length is increased from center to tip , but if the number of poles are 2 how does the flux wave is sinusoidal?

0 Answers  

---

in GEAFOL Cast-Resin trnaformer of 11/.72kv which has tapping of 11550v,11250,11000,10246v in primary side. To obtain 700v. which tapping should be used of HV side as we have 11000v/720v tapping now .

1 Answers  

---

in HVDC transmission system ,monopolar link has one conductor usually a negative polarity and use ground or sea return ?through negative polarity we could pass electricity or not yes means how it is possible

1 Answers   Gyana, NNN,

---

the relationship between phase and line voltages in a 3 phase generator is expressed in what formula?

4 Answers   Omicon,

---