Answer / manan2347

To withstand the axial load we are using thrust bearing in turbine.

Answer / kranti1986

to Reduced the vibrations

Answer / sudarshan sankapl

Thrust bearing it controls the rotor axial displacement.. and it will grip the steam flow in uni direction...

I am applied 100 % pressure on to the air to open control valve,but the valve is not fully closed..and 10-15% is open the valve. how to calibrate the control valve?

3 Answers   OPaL,

---

Good Evening all.My question is - For a feed water line to an equipment if i need to measure the flow we will use orifice /magnetic/vortex depend on cost/spec.If i need to measure a ''Alarm''signal and ''Interlock'' from one point i think we can use orifice type in one location with 2 different tapping points - one for alarm and one for an interlock to flow valve..If in case i need to have both these signals(Alarm & interlock) from magnetic flow meter,is it possible??will 2 seperate sensors will be located inbuilt r we can program it ??..i thk we can have one transmitter with these 2 signals...need to know any technical issues are there?pls clarify

3 Answers  

---

What should be the ideal tapping location for pressure differential transmitter for liquid service. If the tapping taken from the top of the pipe then PDIT will work properly or not. If PDIT do not work properly then what minimum corrective action should be taken in order to solve wrong tapping locations.

1 Answers  

---

how to replace the smart transmitter software

1 Answers   L&T,

---

in which application we use bigger size actuator

5 Answers  

---

what do u mean by compensating?in power plant where are compensating done?how level , flow compensated?

1 Answers   TATA,

---

what is the difference between the microcontroller and PLC?

9 Answers   HAL, Havells,

---

can we create an interrupt in plc through scada?

0 Answers   Glensol, TATA,

---

How to measure the vibration..?

1 Answers   Madhucon,

---

If we increase PI controller what will be action.

1 Answers   IMECO,

---

Calibration of flow transmitter.

1 Answers   CCIE, Power Plant,

---

Explain Difference between Bech set and operating range of control valve

3 Answers  

---