On load tap changer (OLTC) explode? Transformer Vector group: Ynd11 Rated Power: 353MVA Rated Current: 693A Voltage:294/20KV OLTC Type: T III Y1000 110/c 12193w Max Operation Current: 295A Step Voltage: 550V Arrangement in Tx windings: Y Connection Problem: Damage of Unit 1 Generator Transformer On Load Tap Changer (OLTC) Description of Incident: 9.00 a.m. :- Generator No Load test on excitation system started 10.30 a.m :- Carried out AVR change over test 11.30 a.m :- Preparation for Generator Manual Synchronizing test 12.00 a.m :- Manual Synshronizing test started. Observed incoming generator voltage higher than running voltage. CECR operator operated Generator Transformer OLTC to bring down the incoming generator voltage 12.03 a.m :-Generator Transformer abnormal alarm operated at Gen.Control Desk (CECR) CECR operater at Generator transformer bay informed that the transformer oil splashed out from OLTC. CECR operater informed that he heard explosion inside OLTC. Observed Oil level & Oil Flow alaram operated at Tranformer local annunciator. 12.05 am :- CECR operator 'Open Gen Field Breaker” 12.10 a.m. :- Elec1 team inspected the OLTC and found the OLTC rupture disk was broken and oil spilled at OLTC area. - Elec1 found the OLTC top cover bulging. Do anyone know why and possibility cause happen in this OLTC.

9 Answers  

---

Give the selection criteria of a 3 Phase transformer for industrial purposes ?

5 Answers   NDDB, TATA,

---

what happened when we supply a dc current in dc motor?? can it worked properly?

0 Answers  

---

I have 2 KW electric water heater.I am gonna use it in controlling water temp.so I needed to increase or decrease the heating capacity.is there any electrical-electronic circuit for varying the resistance & so current?

1 Answers  

---

how does electrical train works and what type of motors are used to drive the train? which level of supply voltage is used?

22 Answers   Alstom, Infotech,

---

WHY WE USE 4-20mA

5 Answers   Coca Cola,

---

in a 740 kw dc seperately excited motor field voltage is constant about 17.4 volts and armature voltage is500 volts dc. how it is possible to have two different voltages from single transformer of output voltage 500 volts? if any difficulty in question contact ajitsingh.kadian@gmail.com

1 Answers  

---

For which purpose the temp. rise test of transformer is conducted?

2 Answers  

---

lamination figures

0 Answers  

---

How to test Alternator stability test for REF relay

0 Answers   Amprotec,

---

which of the following elements is not present in stainless steel

0 Answers   LASA,

---

when ELCB breaks the circuit than INVERTER auto-connect the circuit to the battery than how can the operetor is safe??

1 Answers  

---