Answer / laxmi narayan

Following the symbol easiest method to read drawing.

Answer / avic

By reading the first part of the manual that explains what the symbols and letter used in the diagrams represents.

how do i tune dearator pr control valve using PID. we set the set point is 0.6kg/cm2 now i want 0.5 to 0.7kg/cm2 limits so what should i give p,i,d values. then pls explain how do set pid values for control valve tuning?

0 Answers   SEWA, Sharjah Electricity and Water Authority SEWA,

---

In vortex flow meter how can measure the frequency of vortex generated by vortex flow meter

4 Answers   Cadila,

---

Thermocouples work as follow:

1 Answers   Dashen Brewery, Tata Power,

---

Can any body tell me about SAP MAINTINANCE MODULE. WHAT IS its function and application. And study material Source about it. I shall be very thankful.

0 Answers  

---

How to do calibration of magnetic flowmeter

1 Answers   Kharafi National,

---

whey we conect ammeter in series and voltmeter in parallel in circuit

1 Answers  

---

What are the advantages and benefits of using PLCs to automate a section of a plant?

2 Answers  

---

What is the difference between dry contact and wet contact?

2 Answers  

---

key exchanges in wpa,wpa2,tls

0 Answers  

---

You are looking at the RS-485-side of an RS-232/RS-485 converter and the power supply voltage for the converter is +5V. Under idle conditions (no transmission), and assuming you have enabled the RS-485 output: what would you expect at: (a) Output A measured against output B (b) Output A measured against ground (c) Output B measured against ground

1 Answers   EIT,

---

How to calculate the Range of level transmitter ?

1 Answers   CPCL, Sejong, SSPL,

---

How many interlocks at turbine? Plz explain briefly

0 Answers   MRPL Mangalore Refinery and Petrochemicals Limited,

---