Interested to Buy Any Domain ? << Click Here >> for more details...
How can I read the electrical drawing easily?
- 2 Answers
- 6619 Views
- Plot Enterprise, I also Faced
- E-Mail Answers
Answer Posted / laxmi narayan
Following the symbol easiest method to read drawing.
| Is This Answer Correct ? | 5 Yes | 1 No |
Post New Answer View All Answers
A valve in series with an orifice plate (DP transmitter), is aligned for constant pressure in the pipeline, if there is an error dx, How to align it in process.
What happen if I install my pressure transmitter below the elevation of pipe in natural gas service?
How to change dcs card in online. (Dsc is maxdna)
what is insdustrial vibration.who it works. give atleast 2 types of insdustrial vibration
when the instrument tapping on pipe line is located below and transmitter is located above the tapping point for liquid service transmitter, what should we do, is there any additional drain valve is required??
why micro controller 8051/52's clock frequency is internally divide by 12 ?? and why it is further divide by 32 in UART serial communication ??
what is a good line as ic engineer as maintenance ,oc, project, calibration ,validation engineer?
types of cable..? Use of every types of cable..?
the pump holds on run indication into the dcs and filed local control panel remote push button condition operaton wrong like when the push button pushing conditions the pump is off and the push button release condition the pump is on totally opposite condition . And control room inside give the stop command into dcs just 1secon relay engage and again normal condition. How can I slove
Hook up resistance decade box to temp.transmitter.
how works encoder in plc
What is the difference between PLC and DDC?
In turbine what does term CDP, NI, NH, HSSOC means.
Explain the working principle of lvdt?
There are two chlorination tonners both are connected to two pressure swithes and the pressure switch is connected to SOV which operates the valve to changeover the tonner selection i.e if pressure one tonner goes low the other tonner should come in line if it is inautomatic selection design a circuit using relays ?
