Answer / devendra_kushwaha27

In vortex flometer, it is natural phenomenon that if you
put an obstruction in the path of flow, automatically
vortex are generated. In this case the important point to
be observed is that the number of vortexes generated are
directly proportional to the velocity of the flowing fluid
but the distance between vortex to vortex remain constant,
while we have the formula v=F.lemda..... where the lemda is
defined as the distance between vortexes which is constant.
and velocity is directly proportional to frequency. Where
we can use several types of sensors to detect the vortexes,
such as piezo electric type sensor. when a vortex will hit
to the sensor the pulse is generated and by calculating the
number of pulses we can determine the velocity and then
flow. YOU can physically observe this case... ... but it is
to be needed to go near river and search the place where
the stones are up than water level. sit there and observe
the phenomenon it is better to of that place where the
depth of water is not more than 6 inch and flowing speed is
not much fast...... cisit that place daily and observe that
when the flowing speed is more that day the more vortexes
are generated

Answer / rajendraa

1.we can measure the frequency at which the shedder is vibrating by using a piezoelectric sensor.
2.other by finding the velocity of the vortices by using an ultrasonic meter.
3.proximity sensors can also be used.

Answer / suresh m (fcri)

The raw signal output from sensor (piezo or other types)
used within the vortex flowmeter can be observed on an
oscilloscope.
This signal will be zero frequency at zero flow and
increases as flowrate is increased.

Answer / jagdish sankharva

use mechanical sensor for measuring of vortices.

Can we use twisted pair cable instead of ethernet for communication?

1 Answers   Yokogawa,

---

what about your moleg in pogrees with company

0 Answers   MahaGenco,

---

Please anyone answer my question, what is the difference between single acting and double acting control valve, in what condition we better choose single acting rather than double acting

2 Answers  

---

why are use only 4 to 20ma. signal.

9 Answers   Otsuka,

---

what is the principal of coriolis mass flowmeter

1 Answers  

---

why we use only 4 to 20ma other than 0 to 16 ma

5 Answers   Invensys, Systech,

---

If the average power during generation is zero, why do the analog meters have + and - ?

1 Answers   Siemens,

---

How to set up the various advanced process controllers, input the proper parameters, and tune those controllers given related control system information.

1 Answers   EID Parry,

---

State 5 different method of level measurements.

3 Answers   SRACO,

---

what is the calibration procedure for magnetic flow meter @ onsite

0 Answers  

---

detail of mass flow meter pricipal

0 Answers  

---

What is difference between magnetic flow transmitter & Electromagnetic flow transmitter?

1 Answers  

---