Answer / awaneesh kumar ojha

Maximum Silt Content as per IS 2386-part2 is 3% by weight and 7% by volume as per CPWD specification

Answer / azam.tamboli

7% for R.C.C and 4% for Brick / Plaster work.

Answer / vbhs

silt content should not be excceded more than 8%

Answer / guest

in my opinion 8 percent max.

Answer / mangesh gavhankar

Maximum 10 percent silt contains is allowed

what do you mean by ssd how it calculated

3 Answers  

1 cubicmeter liquid = how much litre

6 Answers  

what is the calculation of raw material for 0.35cum of m-15

0 Answers   L&T,

how to calculate steel quantity of column from steel design

1 Answers  

5. Two long boundary walls run parallel to each other at a center to center distance of 1 meter apart. The width and height of the first wall are 0.30 m and 2.5m respectively. While those of the second are respectively 0.18m and 3.5m. Plot the distribution of vertical stress intensity due to walls on a horizontal plane, 1m below ground level. The walls have negligible depth of foundation and are made of brick masonry (y = 19.2 kN/m cu)

0 Answers   KIOCL,

Write down a formula to calculate the number of 50Kg bags of cement for moulding of cement blocks of tcm thick by 20cm high by 40cm long on site with a mix ratio of 1 bag of cement to 3 wheelbarrows of sand . the sand is measured at a STRUCK( WATER LEVEL) 65 litres capacity wheelbarrow. TEL: +237 674630019

1 Answers  

Difference between tension and compression zone

3 Answers  

Plastering with cm 1:5 mix( one cement and five sand ) to 12 mm thick. How much Bag of Cement (50 Kg) and Sand (Cum)

4 Answers   L&T, TATA,

Define line type?

0 Answers  

what is derating factor in cable? what does it mean if derating factor is high/low in terms of thermal resistivity of soil?

0 Answers  

lap length formula

7 Answers  

explain yourself?

1 Answers   Infosys, Omaxe, Siscom, TCE,