Answer / sachin tyagi

Parallel of two or more DG with a load
bus bar it is called synchronization
and is use there load is used in
variable form.and we have different
ways of power sourses and for
synchronization voltage , freq,and
phase sequence should be remain same.

the 230 value of voltage which is use in our home . is that value is rms, aerage or peack value of voltage?

5 Answers   L&T,

---

How much of the total hydro power potential has been exploited so far in india?

0 Answers  

---

In simply words(not explain any formula )what do you mean by power factor.?

5 Answers   DRDO,

---

how does bode plot have an advantage over root locus? how does it determine the stability of a system depending upon the location of poles and zeroes?

2 Answers   NBKR,

---

What is the meaning of utility ground and clean ground? How the distribution panel is grounded?

0 Answers  

---

In EB metering we face problem kva jump even in no load condition.can any one help to control this

0 Answers  

---

where is highest transmission voltage is used in india

2 Answers  

---

What is the minimum percentage of power that a powerplant can support in ilanding mode ?

1 Answers  

---

when the flux enters into saturation mode then what will be the secondary voltage of the normal t/f?....high or low ? explain ...how?

1 Answers  

---

Whot is the difference between MCB and MCCB.Whot is the selection critearea for MCCB and MCB for 63 Amp.

5 Answers  

---

why we ht line cable size small rather than lt cable.

4 Answers   Aster Teleservices,

---

what is difference between DC and Ac

5 Answers   Birla,

---