Interested to Buy Any Domain ? << Click Here >> for more details...
What is Synchronization of generator,where and how it is
achieved.
- 1 Answers
- 4611 Views
- HEC, I also Faced
- E-Mail Answers
Answer Posted / sachin tyagi
Parallel of two or more DG with a load
bus bar it is called synchronization
and is use there load is used in
variable form.and we have different
ways of power sourses and for
synchronization voltage , freq,and
phase sequence should be remain same.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
why you don not show protection and type of isolation in key single line diagram?
what you have to see after one week or month from the day of installation of transformer ?
in wind mill use 2100 kw asychronous generator ( induction generator ) rotor voltage : 3300,stator voltage : 690, rpm : 1511 type : MRL063E04 ' we check rotor resistance magger value found following. R-EARTH - 00 M.OHM,Y-EARTH-34 M.OHM,B-EARTH- 33M.OHM R-Y: 31 M.OHM, Y-B: 00 M.OHM,B-R :33 M.OHM HOW CAN I TAKE DECISION?pls ans. quickly
Is single load(eg: three phase motor) having all the components like positive,negative,zero sequence components during fault condition?
A 400 V, 50 Hz, Δ connected synchronous generator has a field reactance of 0.1 Ω and armature resistance of 0.015 Ω. At full load, the machine supplies 1200 A at 0.8 pf lagging. Under full-load conditions, the friction and windage losses are 40 KW and the core losses are 30 KW. What is the machine’s overall efficiency? Ignore any field circuit losses.
can I improve the furnace power factor (10 mva transformer) by adding a capacitor bank before the transformer.Does system power factor vary a lot with the furnace PF?
Sir, My doubt on cable sizing calculation, Load:74 KW calculated cable 1 run 50mm2. Now client asking us to reduce cable size by increasing runs. Sir, My question now when my mind strikes with 2 options 1) Divide load 74/2 = 36 and calculate cable for 36+36 making it 2 runs or 2) Simply i can divide 50mm2 /2 ie. 2 runs of 25mm2 Please suggest me sir
how to generator maintenance (A Check, B check,Etc)
What is class ab operation?
what is the minimum requirement gigaohms for the insulation test using 5kv in 300mm xlpe cable
WHY BLADE & JOW OF ISOLETOR IN SUBSTATION?
STATE USE OF ARC RUNNERS & SPLITTERS ?
How is the gain affected by the introduction of feedback in a control system.
Define step response?
how to calculate the earth fault current
