Answer / mahalingam

1.The flow meters are followed by Bernoulis therom, In the DP the flow is direct proportional to the square root of flow.
2. The use of UPS to the DCS is, the DCS request un interrupted power to continue its operation. During the time of operation if the raw power supply not be available then the entire system connected with the dcs will shutdown its operation.
3. Drum level to be controlled via three element control. feed water flow, steam flow & drum levels are the control variable.
4.Normally globe valves are used in the low pressure drop with steam,Gas, hot water application where the high accurate flow is required. whereas the gate valve gives the larger pressure drop and more flow process mediums like juice and slurry applications.

You are looking at the RS-485-side of an RS-232/RS-485 converter and the power supply voltage for the converter is +5V. Under idle conditions (no transmission), and assuming you have enabled the RS-485 output: what would you expect at: (a) Output A measured against output B (b) Output A measured against ground (c) Output B measured against ground

1 Answers   EIT,

---

Dear friends, I have a question: We work on a project which has some boilers to provide steam for desalination unit. The boiler area is safe and the only hazard source is the fuel lines of boilers. I want to know according to NFPA standard which type of instrument should be selected on the fuel line: Eex Type or Non-Eex type? Thanks in advance

2 Answers  

---

how to tune siemens sipart electro pneumatic positioner..plz tel me..

0 Answers  

---

i want to know the interview format fot gail, instrumentation. pls answer me in habib.sami1003@gmail.com

0 Answers  

---

for what purpose strain guage is used?

5 Answers  

---

defination of radial vibration?

0 Answers   EE Limited, MNC,

---

what is function of ESD , and how is it work, explain with difination

1 Answers   Bapco Bahrain Petroleum Company, BMB,

---

When doing a liquid seal on a differential flow transmitter , most of the time the sealing liquid will be heavier then the process fluid. For wich application will the sealing liquid be lighter than the process fluid if transmitter is mounted below the process line.

0 Answers   Chevron,

---

what is flow

2 Answers  

---

Name some of the common protocol use in automation.

3 Answers   Empower,

---

The DCS stand for________________________. it is composed of the following major components: a:______________ b:______________ c:______________ d:______________

2 Answers  

---

how to make temperature closed loop

1 Answers  

---