Answer / guest

diclaration is performed until the condition gets satisfied

Answer / manas kumar dash

WHIC REAPETEDLY OCCUR IN A PROGRAM

what is droop mode n frequency mode in wood ward governor?

1 Answers   TATA,

---

Why Boiler Drum level transmitter (TX) or level transmitter rang always put -600 to 0 other -900 to 0. Mines range why use….?

4 Answers   Uttam Sugar,

---

You are looking at the RS-485-side of an RS-232/RS-485 converter and the power supply voltage for the converter is +5V. Under idle conditions (no transmission), and assuming you have enabled the RS-485 output: what would you expect at: (a) Output A measured against output B (b) Output A measured against ground (c) Output B measured against ground

1 Answers   EIT,

---

what is cems analyzer explain with principle and drawing ?

0 Answers  

---

IS there any effect of vortex in low pressure side of the transmiter after the orific in feed water line? if yes then what is the calculation?

0 Answers  

---

How to check the SCAN time of DCS ,n dont give therotical answers .How to check the SCAN time of DCS during FAT?

2 Answers  

---

what sud u do if u dont get feedback from control valve?

1 Answers   Siemens,

---

i have calibrate rosemount make level transmitter , wht can i do ? my tank capacity is 30,000 liter

9 Answers   Equate,

---

How to calibrate RC Feeder system in thermal power station?,If any instrument available to calibrate it,ple inform me. make:stock,

0 Answers   TATA,

---

why we are using digital signals for I/O & how to measure this signals is getting or not ?

0 Answers  

---

how to change 4 wire rtd transmitter into a 3 wire rtd transmitter? as our transmitter is working for 4 wire rtd, what should do for working on 3 wire rtd transmitter

1 Answers   HHJ,

---

when we calibrate the DP transmitter at that time which matrial we used in pressure pump?

4 Answers  

---