which safety valve will open first if steam is not been
supplied to turbine.

Answers were Sorted based on User's Feedback



which safety valve will open first if steam is not been supplied to turbine...

Answer / guest

line safety

Is This Answer Correct ?    12 Yes 0 No

which safety valve will open first if steam is not been supplied to turbine...

Answer / hardik085

Main steam safety firstly open due to starvation happen if drum safety open

Is This Answer Correct ?    10 Yes 1 No

which safety valve will open first if steam is not been supplied to turbine...

Answer / nikhil nimje

ESV (EMERGENCY STOP VALVE) will actuate within micro sec to stop flow of main line then turbine stop valve operate

Is This Answer Correct ?    0 Yes 1 No

Post New Answer

More Power Plant Engineering Interview Questions

what's interlock relay ?

3 Answers   International Mega Food Park Limited, National Power Training Institute NPTI,


In a coal fired boiler furnace temp. is high but super heater out let temp. low what reason for this?

6 Answers   ABB, Essar, Gayatri,


Difference between electrical and electronics?

7 Answers   Power Plant,


what is restricted earth fault explain in details

0 Answers   Greenko, JSW,


Why attemperation is required in HRSG in a combined cycle power plant?

10 Answers   Tata Power,






what's the moog valve

0 Answers   Sirte Oil Company,


63.5 ohm NGR is connected with our gas engine genrator running at 500 rpm, 50 hz and synched with WAPDA at 6.3 KV bus voltages, 2500A and 25KA(1 sec). can some one give me proper calculations how it comes 63.5ohm?????

2 Answers   UET,


What should be the neutral and body grounding sysytem for grid (132 KV) parallel generators (440 volts)?

1 Answers   Rahimafrooz,


A 5A rewirable fuse blows when 9A flows.determine the fusing factor?

1 Answers   Schneider, Student, Tata Power,


What are the turbine protections.

2 Answers  


can u please tell me how to calculate the concrete quantity for a under reamed pile? r=300mm,depth=3m for a cylinder and for bulb l=.750mm,width=.525

0 Answers  


why not maintain Ph 7.0 in Boiler because 7 Ph is not acidic and not basic.

4 Answers   Atlas Power,


Categories
  • Civil Engineering Interview Questions Civil Engineering (5085)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4451)
  • Electrical Engineering Interview Questions Electrical Engineering (16632)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1095)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)