what is the density of concrete & steel?
where we are using pycnometer?
what is bulking of sand?
what is under reinforced & over reinforced?
what is balanced section?
Answers were Sorted based on User's Feedback
Answer / itika chaudhary
Density of concrete is 2240-2400 kg/m3.
Density of steel is 7860 kg/m3.
The Pycnometer can be used for determination of the specific gravity of solid particles of both fine grained and coarse grained soils.
As the moisture content of a fixed weight of sand increases, the volume also
increases--up to a point. This is known as bulking of sand.
An under-reinforced beam is one in which the tension capacity of the tensile reinforcement is smaller than the combined compression capacity of the concrete and the compression steel.
An over-reinforced beam is one in which the tension capacity of the tension steel is greater than the combined compression capacity of the concrete and the compression steel.
A balance section is one in which the concrete crushing and steel yielding take place at the same time.
| Is This Answer Correct ? | 8 Yes | 0 No |
Answer / lalit madnawat
Density of concrete=2400 kg/
cum.
Density of r.c.c. =2500 kg/
cum
density of steel = 7850 kg/
cum
| Is This Answer Correct ? | 3 Yes | 0 No |
Answer / suresh bariya
Density of Concrete 2500 Kg /M3
Density of Steel 7850 Kg /M3
It is the phenomena of the increase in the valume of sand
due to water on the surface of sand is called Bulking of
sand.
| Is This Answer Correct ? | 3 Yes | 1 No |
what is minimum dimension for the kitchen & bed room
Do you expect there to be many jobs for civil engineers going into the future? What are the three main drawbacks of being a civil engineer? What are the three best things about being a Civil engineer? What amount of vacation time is available to you? Is the time paid? What are the usual hours of work required? Is it possible, or common, to work from home? How much time do you spend on the site of your projects? What type of schooling is required to be a civil engineer? How many years are required to complete this education?
How much qty of stone ; sand; cement in R/R stone masonry of 136 CUM
How to find quantity of cement bags, sand, coarse aggregate, from 1m3 of concrete of m20 design?
Journal entry Gross salary 10000 Tax 1000 Employee contribution 2000 Employer contribution 2000
at what height brick masonr, block masonry & Concrete wall can construct in a day ?
How can explode a block?
what is plum concreting and how is it can be done what is the ratioo of rubble and concrete
In cement concrete pavements why cracks are develop aolng with logitudinal&tangenteal directions
how many bricks are requir for one unit ho we will caculate
if 20mm aggregate is coming by weight 25 ton in a 10 wheeler hywa ,then what will be total volume of aggregate in cubic feet.
Wats the purpose of lap length? Is it for strength or increasing of span
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)