what is the density of concrete & steel?
where we are using pycnometer?
what is bulking of sand?
what is under reinforced & over reinforced?
what is balanced section?
Answer Posted / itika chaudhary
Density of concrete is 2240-2400 kg/m3.
Density of steel is 7860 kg/m3.
The Pycnometer can be used for determination of the specific gravity of solid particles of both fine grained and coarse grained soils.
As the moisture content of a fixed weight of sand increases, the volume also
increases--up to a point. This is known as bulking of sand.
An under-reinforced beam is one in which the tension capacity of the tensile reinforcement is smaller than the combined compression capacity of the concrete and the compression steel.
An over-reinforced beam is one in which the tension capacity of the tension steel is greater than the combined compression capacity of the concrete and the compression steel.
A balance section is one in which the concrete crushing and steel yielding take place at the same time.
Is This Answer Correct ? | 8 Yes | 0 No |
Post New Answer View All Answers
beam length 73 feet 4 inch,width 01 feet,height 50 inch so every beam load how much? and what quantity of M.S ROD? both side ony two column in middle no column.pls inform me that this is stable or not ? and how much risk of this beam?
how much percent are used 20mm,10mm?
What distance in meters on the ground is the equivalent of one second of arc in longitude or latitude?
what is the method used for marking of cantilevers in hirise buildings by using theodolite
what is mean by reestimation?
RR masonry rate analysis
What is soil enforcement?
how many material required for brickbat water proofing of toilets.
How much cement and sand required for 9"brick wall per square metre
plumbing CPVC fitting FTE Brass full form
do we consider shrinkage factor for calculating cement consumption for CM mixes for different works?
Design a shear wall of length 4.20 m and thickness of 250mm subjected to the following forces.Assume Fck = 25Mpa and Fy = 415Mpa and the wall is a high wall with central part 3440mm x 250mm and two 380mm x 760mm strong bands at each end with following loading. S.No. Loading Axial force Moment Shear 1 DL+LL 1950 600 20 2 Seismic load 250 4800 700
Define What glue is least sticky?
how much repeitation for conventional and maivan formwork?
What is the cost of formwork for columns/beams/rcc walls also what is the cost of shuttering for roof slab at height of 25 feet