Answer / kj

Most generator manufacturers have a requirement of the sets
being regularly serviced. The are also different codes
(e.g. fire codes) which require the regular servicing. The
type of service is usually designated as A to D.
An A service is usually a check of the generator to make
sure all systems are functioning correctly.
This steps up through oil and filter change to replacement
of consumable parts at D.
Consumable parts are the parts such and belts, hoses,
coolant pump, injectors, etc.
Each of these services are set by a time period or hours of
operation similar to the servicing of a car.

is starting current of induction is high or stating current of ransformor is hign ,for the same rating

12 Answers   BARC,

---

what is vector diagram in three phase transformer

1 Answers  

---

Impedance relay is directional relay or non directional relay?

2 Answers   KSEB, NTDC,

---

generator(Deutz 550kv)is runing for 2 hours with load of 900 amp and then it goes in shutdown with alarm fault messege of speed fault although heirtz reading fixed at 50,what does that mean

1 Answers  

---

why field winding is placed on rotor winding not on stator winding in case of synchronous machine?

13 Answers   HAL, TATA,

---

What is the amount of no load current of 630 kVA tranformer voltage ratio 11kV/440V ?

13 Answers  

---

Hello friends i am facing one problem in lighting panel. Frequently neutral link near to MCCB is burning(firing. What may be the reason for this one. Please answer me.

5 Answers  

---

how to calculate the battery AH

0 Answers   Turbo,

---

what is the use of vcb & isolator in substation?

0 Answers  

---

short notes on npn & pnp transisitor..........

5 Answers  

---

Is motor current is dependent on load.

2 Answers  

---

If one d.g. is unable to take full load of system, then second d.g. will take care of partly Load.for this condition RPM of both DG set should be equal.By using Synchronization panel RPM of dg sets are match, is it true?

1 Answers  

---